Replace Stereo Wiring Car. There are three main issues that you can run afoul of while replacing your own head unit: Remove the negative battery terminal.
Wiring Diagram For Car Audio System Wiring Diagrams Nea from free-ringtonea.blogspot.com
Web remove the negative cable and loosen the black wire from it. Connect the new car radio. Simply loosen it enough to pull off the cable.
After Pulling The Stereo Unit Forward, You Should See It Is Wired Inside The Dashboard.
Pull the factory stereo from the dash and disconnect. Web slide removal tools into the slots on the radio's face. Web remove the negative cable and loosen the black wire from it.
Remove The Stereo’s Cabin Paneling With The Pry Tool.
Connect the car's wiring to the adapter harness. Web turn the car off, remove the key, and pop the hood. There should be at least one connector, or wiring.
Web What To Know.
Web the orange wire on a aftermarket car stereo is the illumination wire. You won’t need to remove the bolt all the way; There are three main issues that you can run afoul of while replacing your own head unit:
This Wire Provides Power To The Dashboard Lights So They Can Be Turned On When The Car Is.
Take a look, just in case, that the harness is the same and that it fits into the slot of the radio. Remove the negative battery terminal. The 12v battery wire is yellow, the accessory wire is red, and the dimmer/illumination wire is orange with a white stripe.
Web Pulling Out The Old Stereo.
Connect the new car radio. Web the biggest pitfalls of diy head unit installation. Web using a soldering iron or a soldering torch, heat the wire and feed in your solder slowly until it absorbs into the wire.
